Instrument Technology Corporation - Locating equipment. Water leak detection, pipe and cable locators, video inspection systems, sheath fault locators, gas detectors, ground penetrating radar and more Instrument Technology Corporation - Locating equipment. Water leak detection, pipe and cable locators, video inspection systems, sheath fault locators, gas detectors, ground penetrating radar and more
REPAIR FORM  GET A FREE QUOTE

1230 Power Pack - 30Amp/hr

There is nothing like working in a rural area and suddenly your equipment batteries go "dead". No worries! Our custom designed 1230 Power Pack is designed with you in mind. It has a compact design and durability rating that will never let you down. Simply charge up your unit before heading out, and you will have reliable power that lasts for hours. It is lite weight and a fraction of the cost of its competitor. From your family camping trips to the demands of a busy workday our Power Pac keeps your gear charged and ready when you need it the most. Below you can view details about the 1230 Power Pack sold by ITC.

The 30Amp/hr Battery 1230 Power Pack below made by ITC can be used as a power source for the Vivax Metrotech Pipeline Defect Mapper vLocDM2.

Power Pac - Vivax VM 30 Amp hr Battery Pack - Vivax Metrotech vLocDM Series 2 pipeline defect mapper 1230 Power Pack vLocDM2 vLoc DM2 transmitter vLoc DM2 receiver mylocator2

1230 Power Pack Specs

30 Amp/hr Battery Pack

Vivax DM Usage:

Maximum discharge rate 12 amp/hr @ 12v
@ Max 12 am/hr – 2.5 hours
@ ½ load 6 amp/hr – 5 hours
@ ¼ load 3 amp/hr – 10 hours

Tested run times:

Run times are calculated based on Vivax documentation. Usage times may vary.

1230 Power Pack Test run times - Vivax Metrotech vLocDM Series 2 pipeline defect mapper 1230 Power Pack vLocDM2 vLoc DM2 transmitter vLoc DM2 receiver mylocator2

Output power is set at 33% of 120v maximum when using batteries.
ie: max output at 120v is 150 watts, at 12v it is limited to 50 watts by Vivax design.

Charge Times:

Power Pac - Vivax VM 30 Amp hr Battery Pack - Vivax Metrotech vLocDM Series 2 pipeline defect mapper 1230 Power Pack vLocDM2 vLoc DM2 transmitter vLoc DM2 receiver mylocator2 @ 2 amp setting (recommended) from dead to full - 15 hrs
Power Pac - Vivax VM 30 Amp hr Battery Pack - Vivax Metrotech vLocDM Series 2 pipeline defect mapper 1230 Power Pack vLocDM2 vLoc DM2 transmitter vLoc DM2 receiver mylocator2 @ 3 amp setting from dead to full - 10 hrs

Built-in short protection

Metering indicating:

  1. Watts/hour
  2. Amp/hours
  3. Peak amps
  4. Peak watts
  5. Battery voltage

Power switch (must be set to “Off/Charge” to charge). Meter resets in “off” position.

Case:

  1. Tough injection molded high impact; UV protected ABS outer shell will withstand a 7 foot drop to concrete in warm water or the frigid cold
  2. Silicone rubber o-ring seal

1230 Power Pack weight 21 lbs Includes AC charger NiMH Batteries

Made in the USA

If you have any questions, feel free to contact Instrument Technology Corporation at 800-519-1998. For your convenience, you can request a quote from this site.

Please Call -
800-519-1998

© Instrument Technology Corporation (ITC). All rights reserved.     Website Design by Brymels LLC.     Privacy Policy     Sitemap     Back to top