1230 Power Pack – 30Amp/hr
There is nothing like working in a rural area and suddenly your equipment batteries go “dead”. No worries! Our custom designed 1230 Power Pack is designed with you in mind. It has a compact design and durability rating that will never let you down. Simply charge up your unit before heading out, and you will have reliable power that lasts for hours. It is lite weight and a fraction of the cost of its competitor. From your family camping trips to the demands of a busy workday our Power Pac keeps your gear charged and ready when you need it the most. Below you can view details about the 1230 Power Pack sold by ITC.
The 30Amp/hr Battery 1230 Power Pack below made by ITC can be used as a power source for the Vivax Metrotech Pipeline Defect Mapper vLocDM2.

1230 Power Pack Specs
30 Amp/hr Battery Pack
Vivax DM Usage:
Maximum discharge rate 12 amp/hr @ 12v
@ Max 12 am/hr – 2.5 hours
@ ½ load 6 amp/hr – 5 hours
@ ¼ load 3 amp/hr – 10 hours
Tested run times:
Run times are calculated based on Vivax documentation. Usage times may vary.

Output power is set at 33% of 120v maximum when using batteries.
ie: max output at 120v is 150 watts, at 12v it is limited to 50 watts by Vivax design.
Charge Times:
@ 2 amp setting (recommended) from dead to full – 15 hrs
@ 3 amp setting from dead to full – 10 hrs
Built-in short protection
Metering indicating:
- Watts/hour
- Amp/hours
- Peak amps
- Peak watts
- Battery voltage
Power switch (must be set to “Off/Charge” to charge). Meter resets in “off” position.
Case:
- Tough injection molded high impact; UV protected ABS outer shell will withstand a 7 foot drop to concrete in warm water or the frigid cold.
- Silicone rubber o-ring seal.
1230 Power Pack weight 21 lbs Includes AC charger NiMH Batteries
Made in the USA
If you have any questions, feel free to contact Instrument Technology Corporation at 800-519-1998. For your convenience, you can request a quote from this site.
Please Call – 800-519-1998