Suppliers to the Subsurface Utility Engineering Community
Aervoe Industries Inc.
Aervoe Industries - Multipurpose Marking Paint

Download the brochureFeatures: An economical marking paint that is packaged in a can that may be operated in any positionAervoe Industries Multipurpose Marking Paint (360). It is designed to provide a cost-effective marking wherever needed. Markings from regular paint colors will last up to 2 months. Fluorescent colors fade faster, depending on traffic and exposure.

Colors: Black, Fl. Red-Orange, FL. Yellow, FL. Orange, Fl. Green, Fl. Red, White, Orange, Green, Blue, Yellow, Red, Fl. Pink.

Benefits: Aervoe’s All Purpose Marking Paint is economically priced and provides good visibility in the 60-day range depending on traffic and exposure. It meets standards set by OSHA and APWA/ONE Call Systems. It is not affected by moisture or water and it will not wash away once dry. Can be used with the cap on in Aervoe applicators #244/245. The spray-through cap eliminates accidental discharge. Each can is non-clogging and empties completely.

Uses: This product is designed to adhere to most surfaces - paved or unpaved. It can be used for marking at construction sites, locator and utility identification, mining, and other general marking requirements. This product is not recommended for use on short cut grass such as golf course greens.

Application: Shake can well before use and for at least 1 to 2 minutes after agitator ball is head. Remove tab from tamper-resistant cap. With proper alignment of the activator bar, this product can be used with the cap on in Aervoe applicators #244/245. Apply paint 3 to 4 inches from surfaces as a writing tool, and 5 to 8 inches in the applicator for a 3/4-inch line, or continuous directional mark. Keep can in motion during use to prevent puddling. Agitate can periodically during application. For best results, use at temperatures between 60°F and 80°F (16°C and 27°C).

Limitations: Please refer to the Material Safety Data Sheet for specific information on material hazards, etc. This aerosol product is designed to spray at an angle not greater than 30° from vertical. Do not apply additional product until the previous coat is dry. Do not apply if surface is wet. Do not store at temperatures below 32°F (0°C).