Suppliers to the Subsurface Utility Engineering Community
Aervoe Industries Inc.
Aervoe Industries - Fugitive Marking Paint

Download the brochureFeatures: A unique, UV-sensitive marker designed in direct response to comunity concerns to minimizeAervoe Industries Fugitive Marking Paint insightly marks in visually sensitive areas, long after construction and surveys are completed. With its patent pending formula, Fugitive Marker colors progressively fade to clear in 30 to 35 days, depending on direct sun exposure and traffic. It is designed to be operated only in an upside down position. 

Colors: Fl. Red, Fl. Orange, FL. Yellow, Fl. Pink

Benefits: Ideal for use in visually sensitive areas. Markes progressively fade over a 30 to 35 day preiod to a clear, opaque mark. Can be used with the cap on in the Aervoe #244 Spot Marker or #245 Marking Stick. The spray-through cap eliminates accidental discharge. each can is non-clogging and empties completely.

Uses: It will mark and adhere to most surfaces, including asphalt, concrete, gravel, and wood. It is ideal for utility identification on private property, but can also be used for marking at construction sites, and other general marking requirements where short term identification is desired. It is not recommended for use on turf surfaces.

Application: Shake can for 1 to 2 minutes after rattle agitator ball is heard. Remove safety tab, invert can, and apply 3 to 4 inches from the surface for writing symbols and numbers. Apply 5 to 8 inches from the surface for 3/4" line or continuous direction tracks. Keep can in motion during use to prevent puddling due to high delivery paint stream. For best results, use at temperatures between 50° and 80°F (10° and 27° C). If cap has been removed, replace it for storage and color identification. Clear spray tip after each use by turning can upright and spraying for 2 to 3 seconds. fer to the Material Safety Data Sheets for specific information on material hazards, etc. This aerosol product is designed to spray at an angle not greater than 30° from vertical. Do not apply additional product until the previous coat is dry. Do not apply if surface is wet. Do not store at temperatures below 32°F (0°C).

Limitations: Please refer to the Material Safety Data Sheet for specific information on material hazards, etc. This aerosol product is designed to spray upside down or at an angle not greater than 30° from vertical. Use caution if surface is wet, or if rain is imminent within 4 hours of application. Do not apply additional product until the previous coat is dry. On fresh asphalt or other porous surfaces, removal may be hampered due to solvent/pigment penetration.